APPENDIX I: DEEP WATER FORDING KITTM 9-2350-256-201-11 CREW FAN AND BOOM BOOT DRAIN SHUTOFF CLAMP1Tape crew fan switch, located on accessoriespanel, to OFF position with adhesive tape (TableI-1, item 7).2Remove ventilating blower assembly (1) byremoving three screws (2), three lockwashers (3),and three nuts (4).3Apply caulking compound (Table I-1, item 3) toseal assembly (5) and place seal assembly intoopening of crew fan housing (6). Tighten sealassembly screws until watertight fit is obtained.4Install ventilating blower assembly (1) with threescrews (2), three new lockwashers (3), and threenuts (4).5Install kit-furnished clamp (7) on crew fanhousing (6) drain hose.6Install one kit-furnished clamp (8) on right andleft drain hoses of boom cylinder boot (9).1-12 BILGE PUMP1Remove rear center floor plate (1) and stowagebasket forward intermediate left floor plate (2),and retain.2Remove rear intermediate right access cover (3).CAUTIONDo not apply adhesive sealant to fireextinguisher nozzle caps.3Install kit-furnished rubber cap (4) in two fireextinguisher nozzles (5) in main winchcompartment.NOTEAll of the following items are kit furnished unless otherwise noted.4Install strainer assembly (6) and bilge pump assembly (7) with four screws (8), four new lockwashers (9),and eight flat washers (10).5Install bent tube (11) with spanner wrench (Table I-1, item 10) and existing wiring harness (12) to bilgepump assembly (7).6Connect hose (13) to bent tube (11) with clamp (14).I-10
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
