APPENDIX I: DEEP WATER FORDING KIT

TM-9-2350-256-20 Carrier Cargo Tracked 6-Ton M548A1 (2350-01-096-9356) M548A3 2350-01-369-6081 Manual
Page Navigation
1338

TM 9-2350-256-20 l-5 APU-Continued APPENDIX I: DEEP WATER FORDING KIT 2 3 4 5 APU access door must be secured prior to performing any work on unit. Unless properly secured by a strap, access door can swing shut and injure personnel w o r k i n g o n u n i t , especially if spare roadwheel is mounted in place on hull. Remove access (1) to expose electrical terminals. Apply adhesive sealant (Table I-1, item 4) on all exposed exterior and interior electrical terminals. Install access (1). Install two kit-furnished screws (2) in holes on bottom of muffler and apply adhesive sealant (Table I-1, item 4) around head of each screw. 6 Install APU access cover (see paragraph 9-49). 7 Install kit-furnished seal assembly (3) into air inlet, located above APU engine compartment. 8 Attach two kit-furnished S-hooks (4) to ends of each kit-furnished chain (5, 6, and 7). 9 Attach S-hooks (4) of chains (5 and 6) to muffler guard (8) by using new lockwasher (9) and existing screws (10). 10 Attach S-hook (4) of chain (7) to muffler guard (8) using new lockwasher (9) and existing screw (10). 11 Attach kit-furnished plug (11) to chain (7) Shook (4) and install into personnel heater exhaust pipe (12). 12 Attach kit-furnished plug (13) to chain (5) S-hook (4) and install into opposite end of personnel heater exhaust pipe (12). 13 Attach kit-furnished plug (14) to chain (6) S-hook (4) and install into end of APU muffler (15). I-4

Privacy Statement
Press Release
Contact