SECTION V: TROUBLESHOOTlNG TM 9-2350-256-20WARNINGRemove all jewelry such as rings, dog tags,bracelets, etc. If jewelry contacts a metalsurface a direct short may result in instantheating of tools, damage to equipment, andinjury or death to personnel.JRemove four screws (8) and four lockwashers (9) andrelease electrical accessories panel (10). Reconnectelectrical accessories panel wiring harness toelectrical accessories panel. Disconnect wire 38/518from winch light switch side of 15 A circuit breaker.Place red lead of multimeter on terminal of 15 Acircuit breaker and black lead to ground. TurnMASTER switch on and check for voltage. TurnMASTER switch OFF. If voltage is present,repair/replace wire 38/518 of bilge pump main powerwiring harness from 15 A circuit breaker to electricalaccessories panel wiring harness connector (seeparagraph 6-84). If voltage is not present, go to stepK.KReconnect wire 38/518 to winch light switch side of 15A circuit breaker. Disconnect wire 38/518 from panelconnector side of 15 A circuit breaker. Place red leadof multimeter in wire 38/518 and black lead to ground.Turn MASTER switch on and check for voltage. TurnMASTER switch OFF. If voltage is present, replace15 A circuit breaker (see paragraph 6-9). If voltageis not present, repair/replace wire 38 from pin A to 15A circuit breaker (see paragraph 6-9).2-245
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business