HYDRAULIC RESERVOIR MONITORING SYSTEM GAGE AND TRANSMITTER (cont)

HYDRAULIC RESERVOIR MONITORING SYSTEM GAGE AND TRANSMITTER (cont) - TM-9-2350-256-20_416

EXHAUST SMOKE GENERATING SYSTEM - TM-9-2350-256-20_418

TM-9-2350-256-20 Carrier Cargo Tracked 6-Ton M548A1 (2350-01-096-9356) M548A3 2350-01-369-6081 Manual
Page Navigation
404

SECTlON V: TROUBLESHOOTING TM 9-2350-256-20 WARNING Remove all jewelry such as rings, dog tags , bracelets, etc. If jewelry contacts a metal surface a direct short may result in instant heating of tools, damage to equipment, and injury or death to personnel. F Reconnect flasher system panel wiring harness to hydraulic reservoir disconnect. Disconnect wire 664 from hydraulic oil temperature transmitter (see paragraph 12-8). Place red lead of multimeter in wire 664 and black lead to ground. Turn MASTER switch on and check for voltage. Turn MASTER switch OFF. If voltage is present, replace hydraulic oil temperature transmitter (see paragraph 12-8). If voltage is not present, repair/replace wire 664 from hydraulic reservoir disconnect to hydraulic oil temperature transmitter (see paragraph 6-88). G Reconnect wire 325 of switch panel, radio, and bilge pump to bulkhead wiring harness from 15 A circuit breaker. Open air inlet doors (TM 9-2350-256-10). Disconnect wire 48 pin A from bulkhead to master relay wiring harness. Place red multimeter lead in socket and black lead to ground. Turn MASTER switch on and check for voltage. Turn MASTER switch OFF. If voltage is present, repair/replace switch panel, radio, and bilge pump to bulkhead wiring harness (see paragraph 6-53). If voltage is not present, troubleshoot master relay circuit (see paragraph 2-19, master relay fails to operate). 2-349

Privacy Statement
Press Release
Contact