TM 9-2350-256-20CHAPTER 3: MAINTENANCE OF ENGINE3-4REPLACE ENGINE REAR MOUNT AND BASE ASSEMBLY-Continueda. REMOVAL1 Remove horizontal shaft (1) from universal joints (2and 3) at each end of shaft by removing two cotterpins (4) and two straight pins (5).2 Remove universal joint (2) from base assembly (6)by, removing cotter pm (7) and straight pin (8).3 Remove base assembly (6) by removing fourscrews (9) and four lockwashers (10).4 Remove shaft (11) from universal joints (12 and 13)at each end of shaft by removing two cotter pins(14) and two straight pins (15).5 Remove drive assembly (16) by removing threescrews (17), three lockwashers (18), and three nuts(19).6 Remove two universal joints (3 and 12) from driveassembly (16) by removing two cotter pins (20) andtwo straight pins (21).7 Remove two couplings (22) from drive assembly(16) by removing two setscrews (23).8 Remove two keys (24) from drive assembly (16)3 - 1 8Change 1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
