TM 9-2350-256-209Remove universal joint (13) from vertical shaft (25) byremoving cotter pin (26) and straight pin (27).10Loosen collar (28) and remove vertical shaft (25).11Remove identification (ID) plate (29) and bracket (30)by removing four screws (31) and four lockwashers(32).12Remove drive assembly bracket (33) by removingfour screws (34) and four lockwashers (35).b. INSTALLATION1Install drive assembly bracket (33) with four screws(34) and four new lockwashers (35).2Install ID plate (29) and bracket (30) with four screws(31) and four new lockwashers (32).3Install vertical shaft (25) and tighten collar (28).4Install universal joint (13) on vertical shaft (25) withstraight pin (27) and new cotter pin (26).5Install two keys (24) to drive assembly (16).6Install two couplings (22) to drive assembly (16) withtwo setscrews (23).7Install two universal joints (3 and 12) to driveassembly (16) with two straight pins (21) and two newcotter pins (20).8Install drive assembly (16) with three screws (17),three new lockwashers (18), and three nuts (19).9Install shaft (11) to two universal joints (12 and 13)with two straight pins (15) and two new cotter pins(14).10Install base assembly (6) with four new lockwashers(10) and four screws (9).11Install universal joint (2) to base assembly (6) withstraight pin (8) and new cotter pin (7).12Install horizontal shaft (1) to universal joints (2 and 3)with two straight pins (5) and two new cotter pins (4).NOTEFollow-on maintenance:Install powerplant (seeparagraph 3-1)3-19
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
