REPLACE ROADWHEEL ARM ASSEMBLY

INSTALLATION (cont) - TM-9-2350-256-20_844

TM-9-2350-256-20 Carrier Cargo Tracked 6-Ton M548A1 (2350-01-096-9356) M548A3 2350-01-369-6081 Manual
Page Navigation
832

TM 9-2350-256-20 CHAPTER 8: MAINTENANCE OF SUSPENSION SYSTEM 8-3 REPLACE ROADWHEEL ARM ASSEMBLY THIS TASK COVERS a. Removal b. Installation INITIAL SET-UP Tools: Materials/Parts-Continued: • Handle (Appendix C, item 17) • Seals (48) (Appendix G, item 259) • Replacer (Appendix C, item 41) • Washers, key (12) (Appendix G, item 276) • Wrench, spanner (Appendix C, item 60) • Wrench, torque, 0-175 lb-ft (0-237 N•m) Equipment Conditions: (Appendix C, item 61) • Roadwheel removed (see paragraph 8-l) • Torsion bar removed (see paragraph 8-2) Materials/Parts: • Compensating idler link (see paragraph 8-8) or • Grease (Appendix D, item 13) shock absorber (see paragraph 8-12) disconnected • Oil, OE (Appendix D, item 18) • Track tension loosened (refer to • Solvent, dry-cleaning (Appendix D, item 9) TM 9-2350-256-10) • Gaskets (24) (Appendix G, item 30) • Lockwashers (72) (Appendix G, item 144) Personnel Required: Two a. 1 2 REMOVAL Remove six screws (1) and six lockwashers (2) from roadwheel arm retainer (3). Roadwheel arm assembly is heavy, use care when removing roadwheel arm assembly to avoid injury. Remove roadwheel arm assembly (4) and gasket (5) from roadwheel arm support housing (6) using two removed screws (1) as jackscrews in holes (7) provided. Bend back and straighten tangs of key washer (8) from bearing nut (9). 3 4 5 6 Remove bearing nut (9) and key washer (8). Remove bearing washer (10). Remove inner bearing (11) with bearing race (12) and spacer (13). 8 - 6

Privacy Statement
Press Release
Contact