TM 9-2350-256-34
0068 00
Adjustment
WARNING
Test components (pressure gages, hoses, and fitting) must be capable of withstanding a working pressure
of 19502050 psi (13,44514,135 kPa).
NOTE
VEHICLE PREPARATION--Perform steps 1 thru 3 for vehicle preparation.
1.
Install pressure gage in rear gage port (toward rear of vehicle) (20) on boom combination control valve (21).
2.
If using load cell or calibrated weights, rig a four-part line and extend the boom to an 8-ft (2.44-m) reach. Attach load cell or
weights.
Load cell must be anchored.
If a load cell or weights are not available, place boom in STOW position. Then block boom in a partially raised
position using 2x4 wooden blocks on top of each armor air intake cover. (Covers are located at the top rear of the crew
compartment.)
0068 00-7