TM 9--2350--292--20--1
0216 00--2
MANUAL FUEL SHUT--OFF CONTROL ASSEMBLY REPLACEMENT --
CONTINUED
0216 00
Removal--Continued
5. Remove two cotter pins (12), two flat washers (13) and connecting link (14) from connector (15) and shut--off lever
(16). Discard cotter pins.
6. Loosen nut (17), remove connector (15) and nut (17) from control assembly (3).
7. Remove nut (18), preformed packing (19), flat washer (20), two nuts (21), lockwasher (22) and control assembly
(3) from engine guide (23). Discard preformed packing and lockwasher.
8. Remove lockwasher (24) and nut (25) from control assembly (3). Discard lockwasher.
9. Remove three screws (26), two lockwashers (27), lockwasher (28) and three loop clamps (29) securing control
assembly (3) to hull. Discard lockwashers.
10. Pull control assembly (3) through bulkhead and grommet (30). Remove control assembly (3) from vehicle.
11. Remove grommet (30) from bulkhead. Discard grommet.
12. Inspect parts for damage and replace as required.
Figure 27
12
13
16
17
14
19
20
21
24
25
FORWARD
22
3
15
18
21
26
27
29
29
27
26
29
28
26
30
23