TM 9--2350--292--20--1 0217 00--2 FUEL HOSE ASSEMBLIES, FITTINGS AND VALVES REPLACEMENT -- CONTINUED 0217 00 Installation 1.   Apply sealing compound to all male pipe threads. NOTE A minimum of two decals shall be applied to the hose as- sembly. A decal shall be wrapped around the hose as- sembly within 5.00 inches (127.00 mm) of each end. The maximum allowable distance between decals shall be 36.00 inches (0.91 m). The word “FUEL” shall be visible after application. 2.   Install decals (45) on hose assemblies 5, 9, 17, 16, 21, 24, 2, 34 and 40, if damaged or missing. 3.   Install hose assemblies, tubes, brackets and fittings in accordance with the following legend and illustration. 4.   Secure hose assemblies, tubes and brackets to vehicle with clamps, attaching hardware and new lockwashers as shown in legend and illustration. LEGEND: 1. Adapter unions (2) 24. Hose assembly 2. Hose assembly 25. Pipe elbows (2) 3. Pipe bushings (2) 26. Left fuel tank 4. Pipe elbows (2) 27. Pipe coupling 5. Hose assembly 28. Personnel heater (WP 0529 00) 6. Quick--disconnect coupling half 29. Hose assembly 7. Round connecting ring 30. Grommet 8. Quick--disconnect coupling half 31. Pipe coupling 9. Hose assembly 32. Pipe bushing 10. Pipe elbow 33. Pipe tee 11. Metal tube assembly 34. Hose assembly 12. Right fuel tank 35. Pipe reducer 13. Loop clamps (5) 36. Front fuel tank 14. Lockwashers (5) 37. Loop clamp 15. Screws (6) 38. Hose assembly 16. Hose assembly 39. Tee 17. Hose assembly 40. Hose assembly 18. Pipe couplings (4) 41. Adapter 19. Adapter unions (2) 42. Quick--disconnect coupling half 20. 21. 22. 23. Pipe elbow Hose assembly Quick--disconnect coupling half Round connecting ring 43. 44. 45. Manual fuel shut--off control assembly (WP 0216 00) Lockwasher Decal (As Required)