TM 9--2350--292--20--1
0290 00--5
WIRING HARNESS AND CABLE REPAIR -- CONTINUED
0290 00
TYPICAL MALE--TYPE PANEL MOUNTING RECEPTACLE
Disassembly
1. Heat and remove boot (1) from rear of nut (2).
2. Remove nut (2) from shell (3) and slide nut (2) over cable (4).
3. Drive pin contacts (5) out through rear of shell (3) with pin extractors.
4. Unsolder or cut pin contacts (5) from cable leads (6).
Assembly
1. Strip leads (6) insulation equal to depth of wells in pin contacts (5).
2. Insert leads (6) into wells in pin contacts (5) and solder or crimp leads (6) to pin contacts (5).
3. Push pin contacts (5) into shell (3) from rear until seated.
4. Install nut (2) on shell (3).
5. Apply a thin coat of adhesive to boot (1).
6. Install boot (1) on nut (2).
1
3
2
5
5
4
6
TYPICAL FEMALE--TYPE PANEL MOUNTING RECEPTACLE
Disassembly
1. Heat and remove boot (1) from rear of nut (2).
2. Remove nut (2) from shell (3) and slide nut (2) over cable (4).
3. Drive socket contacts (5) out through rear of shell (3) with socket extractors.
4. Unsolder or cut socket contacts (5) from cable leads (6).
1
3
2
5
5
4
6
