BRAKES DRAG ON ONE OR BOTH SIDES

BRAKES DO NOT STOP EFFECTIVELY (cont) - TM-9-2350-292-20-1_207

ENGINE DOES NOT RESPOND PROPERLY TO THROTTLE CONTROLS

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
164

TM 9--2350--292--20--1 BRAKES DRAG ON ONE OR BOTH SIDES 0037 00 THIS WORK PACKAGE COVERS: Brakes Drag On One Or Both Sides INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 1, WP 0717 00) Equipment Conditions Output reduction access covers removed (WP 0453 00) Personnel Required Two Do levers touch their stops? Inspect brake apply adjustment levers (WP 0356 00 or WP 0357 00). no yes Are all parts in good condition and operating properly? 1. Apply and release brakes 3 to 4 times (TM 9--2350--292--10). 2. Observe brake apply adjustment levers for proper return to stops. 3. If brakes do not fully release, check for binding, bent or broken parts. Adjust brake linkage (WP 0356 00 or WP 0357 00). Verify fault is corrected. no yes Repair or replace faulty parts (WP 0365 00). Verify fault is corrected. Do brakes still drag? Operate vehicle (TM 9--2350--292--10). no yes Replace faulty output reduction unit (WP 0354 00). Verify fault is corrected. A B C Fault corrected. WARNING Remove rings, bracelets, wristwatches, and neck chains before working on any vehicle. Jewelry can catch on equip- ment and cause injury, or may short across an electrical circuit and cause severe burns or electrical shock. END OF TASK 0037 00--1/2 blank

Privacy Statement
Press Release
Contact