ENGINE FAILS TO CRANK WHEN STARTER SWTICH IS PRESSED (cont)

ENGINE FAILS TO CRANK WHEN STARTER SWTICH IS PRESSED (cont) - TM-9-2350-292-20-1_229

ENGINE FAILS TO CRANK WHEN STARTER SWTICH IS PRESSED (cont) - TM-9-2350-292-20-1_231

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
186

TM 9--2350--292--20--1 0041 00--12 ENGINE FAILS TO CRANK WHEN STARTER SWTICH IS PRESSED -- CONTINUED 0041 00 CONTINUED FROM STEP X Is continuity present at both points? no yes Y 1. Disconnect harness 3W206 P1 from engine disconnect. 2. Place one multimeter lead on pins B and E (one at a time) while holding other lead to vehicle ground. Check for continuity. Repair (WP 0290 00) or replace (WP 0302 00) harness 3W206. Verify fault is corrected. yes no Repair (WP 0290 00) or replace (WP 0300 00) harness 3W202. Verify fault is corrected. Is 24 V dc present? 1. Reconnect harness 3W143 P1 at engine disconnect. 2. Remove powerpack (WP 0188 00). 3. Install engine ground hop kit (WP 0189 00). 4. Disconnect harness 3W202 connector from low voltage starter protection module. 5. Turn MASTER switch ON (TM 9--2350--292--10). 6. Place multimeter red lead in harness 3W202 connector socket A and black lead to ground. Check for voltage. 7. Turn MASTER switch OFF (TM 9--2350--292--10). Z CONTINUED ON NEXT PAGE FORWARD

Privacy Statement
Press Release
Contact