TM 9--2350--292--20--1
0082 00--4
ENGINE BATT/GEN GAUGE READS IN YELLOW OR LOWER RED REGION
WITH MAIN ENGINE RUNNING -- CONTINUED
0082 00
Does gauge return to green region?
1. Remove left side air intake grille above voltage
regulator (TM 9--2350--292--10).
2. Reset voltage regulator (TM 9--2350--292--10).
3. Start engine (TM 9--2350--292--10).
4. Place GENERATOR switch to ON position,
turn FUEL PUMP switch ON
(TM 9--2350--292--10).
5. Turn engine voltage regulator OFF then ON
(TM 9--2350--292--10) and observe BATT/GEN
gauge.
6. Place GENERATOR switch in OFF position
and turn FUEL PUMP switch OFF
(TM 9--2350--292--10).
7. Shut down engine (TM 9--2350--292--10).
no
yes
Voltage regulator
circuit breaker was
tripped and is reset.
K
CONTINUED ON NEXT PAGE
CONTINUED FROM STEP A
L
1. Remove switch panel from bracket (WP 0242 00)
and reconnect ground strap to switch panel.
2. Disconnect harness 4W101 P1 from switch
panel.
3. Turn FUEL PUMP switch and MASTER switch
ON (TM 9--2350--292--10).
4. Place multimeter red lead on harness 4W109 J3
pin N and black lead to ground. Check for
voltage.
5. Turn FUEL PUMP switch and MASTER switch
OFF (TM 9--2350--292--10).
Is 24 V dc present?
no
yes
Go to Step O.