NO POWER WHEN MASTER SWITCH IS TURNED ON (cont)

NO POWER WHEN MASTER SWITCH IS TURNED ON (cont) - TM-9-2350-292-20-1_621

NO POWER WHEN MASTER SWITCH IS TURNED ON (cont) - TM-9-2350-292-20-1_623

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
578

TM 9--2350--292--20--1 0126 00--5 NO POWER WHEN MASTER SWITCH IS TURNED ON -- CONTINUED 0126 00 Is continuity present? 1. Remove switch panel from vehicle (WP 0242 00). 2. Disconnect lead 459 from switch S1. 3. Place one multimeter lead on each switch S1 connector pin. Check for continuity. no yes Replace switch S1 (WP 0242 00). Verify fault is corrected. no yes Replace 30--amp circuit breaker (WP 0270 00). Verify fault is corrected. H I CONTINUED ON NEXT PAGE 1. Reconnect harness 3W218 lead 400/459B to circuit breaker. 2. Disconnect harness 3W142 lead 400/459B from bulkhead side of 30--amp circuit breaker. 3. Place multimeter red lead on 30--amp circuit breaker pin and black lead to ground. Check for voltage. Is 24 V dc present? CONTINUED FROM STEPS C AND G

Privacy Statement
Press Release
Contact