TM 9- 2350- 292- 20- 2
0390
00-
3
PIVOT ARM ASSEMBLY REPAIR -- CONTINUED
0390
00
Installation
WARNING
CAUTION
Do not apply pressure sensitive tape when ambient tem-
perature is below 45°F (7.2° C). Failure to comply may
cause loss of screw torque and equipment damage.
1.
Apply pressure sensitive tape or sealing compound to mounting surface of pivot arm assembly (1).
2.
Raise pivot arm assembly (1) to mounting position with hydraulic jack.
3.
Apply sealing compound under the heads and on threads of screws (2).
4.
Install pivot arm assembly (1) to vehicle hull with 11 screws (2) and 11 new lockwashers (3). Torque 11 screws (2)
to 245- 270 lb- ft (332- 366 NSm).
5.
Remove hydraulic jack from under vehicle.
Figure 178
1
2
3
NOTE
FOLLOW--ON MAINTENANCE:
Install suspension arm assembly (WP 0388 00)
Connect track, if disconnected
(TM 9- 2350- 292- 10)
END OF TASK
0390 00- 3/4 blank