TM 9--2350--292--20--2
0499 00--2
MAIN WINCH WIRE ROPE ASSEMBLY REPLACEMENT -- CONTINUED
0499 00
Removal
1. Align winch drum (1) with wedge clamping screws (2) accessible through side access hole (3) in main winch
housing (4).
2. Remove tension from wire rope, disengage power take off unit and shutdown engine
(TM 9--2350--292--10).
3. Remove nonelectrical wire (5) from two wedge clamping screws (2). Discard nonelectrical wire.
4. Remove two wedge clamping screws (2) from winch drum (1).
5. Align winch drum (1) as necessary to remove wedge (6) from winch drum (1) using brass drift and hammer or
slide puller.
6. Manually pull wire rope (7) until wire rope (7) is even with trumpet (8).
NOTE
Wire rope must be pulled through trumpet from outside of
vehicle.
7. Remove wire rope (7) from winch drum (1).
8. Inspect parts for damage and replace as required.
Figure 261
5
2
1
6
7
8
2
3
4
