NEUTRAL SAFETY SWITCH, STEERING CONTROL LOCK AND BRAKE LOCK ADJUSTMENT (OLD CONFIGURATION)

NEUTRAL SAFETY SWITCH, STEERING CONTROL LOCK AND BRAKE LOCK ADJUSTMENT (OLD CONFIGURATION) - TM-9-2350-292-20-2_87

TM-9-2350-292-20-2 Recovery Vehicle Heavy Full-Tracked: M88A2 (NSN 2350-01-390-4683) (EIC:ACQ) Manual
Page Navigation
60

TM 9--2350--292--20--2 0358 00--1 NEUTRAL SAFETY SWITCH, STEERING CONTROL LOCK AND BRAKE LOCK ADJUSTMENT (OLD CONFIGURATION) 0358 00 THIS WORK PACKAGE COVERS: Adjustment INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 1, WP 0717 00) Equipment Conditions Vehicle parked on level surface with tracks blocked (TM 9--2350--292--10) Shifting control linkage adjusted (WP 0408 00) Driver’s seat in stowed position (TM 9--2350--292--10) Subfloor plate #6 removed (WP 0454 00) References TM 9--2350--292--10 Adjustment 1. Place shift control lever (1) in PARK (P) position (TM 9--2350--292--10). 2. Push brake pedal (2) down as far as possible. Brake pedal (2) should lock in down position. 3. If brake pedal (2) does not lock in down position, loosen two nuts (3) on rod (4). 4. Adjust rod (4) until brake pedal (2) locks in down position. 5. Release brake pedal (2). If brake pedal (2) does not release, adjust rod (4) until it does. 6. Check that brake pedal (2) will lock and release properly. If brake pedal (2) operates properly, tighten two nuts (3). Figure 168 1 2 3 4 3 FORWARD

Privacy Statement
Press Release
Contact