With a blunt chisel or screwdriver, drive a portion of the bushing intothe notch previously tUse sump or cover with 7/8" diameter bearingand 19094 guide.Reassemble sump to cylinder with pilot guide bushing in the sumpbearing.Place finish reamer on pilot and insert the pilot into the cylinderbearing until the tip of the pilot enters the pilot guide bushings in thesump bearing. Fig. 10.Lubricate the reamer with kerosene. fuel oil or-Stoddard Solvent. thenream the bushing turning the reamer clockwise with a steady evenpressure until reamer is completely through the bearing. Improperlubricants will produce a rough bearing surface. Remove sump andpull reamer out without backing it through the bearing. Remove pilotguide bushing: clean out all reaming chips.On most cylinders. the breaker point plunger hole enters the reamedout main bearing and .a burr is formed by the counterbore reamingoperation. Burr can be removed using 19058 finish reamer. Clean outdirt and reaming chips.5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business