TM 9-2350-238-34-2
2-20. MAINTENANCE OF WINCH LEVEL WIND AND CONNECTING LINK SLIDE
(CONT).
DISASSEMBLY (CONT)
NOTE
19 Remove two level wind sensing push
Rotate cable guide to allow for re-
stitches (53) with attached parts from
moval of spring pin.
level wind bracket (54).
14 Using hammer and punch, remove spring
20 Remove two female terminal assemblies
Pin (42) from manual control lever (43).
(55), two bushing sleeve insulators (56),
15 Remove manual control lever (43), sleeve
spacer (44), and helical spring (45), from
shaft of cable guide (37).
16 Using soft-faced hammer, remove cable
guide (37) and two thrust washer bear-
ings (46).
17 Using arbor press, remove two needle
roller bearings (47) from level wind hous-
ing (10).
18 Remove machine screw (48), Iockwasher
(49), chain assembly (50), quick release
pin (51), and sleeve bushing (52) from
cable guide (37).
and two electrical shells (57) from each
level wind sensing push switch (53).
21 Remove three nuts (58), three lock-
washers (59), three flat washers (60),
three hexagon head capscrews (61), and
level wind bracket (54) from level wind
housing (10).
22 Remove two sleeve bearings (62) from
level wind housing (10).
23 Remove lubrication fitting (63) from level
wind housing (10).
24 If damaged, remove three inserts (64)
from level wind housing (10).
2-24
