CHAPTER 9: MAINTENANCE OF HULL-AND CAB-RELATED COMPONENTS
TM 9-2350-256-20
9-78
REPLACE/REPAIR/SERVICE ACCELERATOR CONTROLS AND LINKAGES-
Continued
27
Remove bearing housings (78 and 79) by removing from each two nuts (80), two lockwashers (81), two screws
(82), and two flat washers (83).
28
Remove bearing housings (78 and 79) from shaft (84).
29
Remove screw (85), self-locking nut (86), and rod (87).
30
Remove bearing (88) and nut (89) from each end of rod (87).
31
Remove rod (90) by removing screw (91) and self-locking nut (92) from each end.
32
Remove bearing (93) and nut (94) from each end of rod (90).
33
Remove bracket assembly (95) and bell crank assembly (96) by removing two nuts (97), two washers (98), and two
screws (99).
9-176
