CHAPTER 9: MAINTENANCE OF HULL-AND CAB-RELATED COMPONENTS
TM 9-2350-256-20
9-78
REPLACE/REPAIR/SERVICE ACCELERATOR CONTROLS AND LINKAGES-
Continued
g.
INSTALLATION
1
Install bell crank assembly (96) with flat washer (102),
retaining ring (101), and lubrication fitting (100).
2
Install bracket assembly (95) and bell crank assembly
(96) with two screws (99), two washers (98), and two
nuts (97).
3
Install nut (94) and bearing (93) to each end of rod
(90).
4
Install self-locking nut (92) and screw (91) to each end
of rod (90).
5
Install nut (89) and bearing (88) to each end of rod
(87).
6
Install rod (87) with screw (85) and self-locking nut (86).
7
Install bearing housings (78 and 79) to shaft (84) each with two screws (82), two flat washers (83), two new
lockwashers (81), and two nuts (80).
9-178
