SECTION V: TROUBLESHOOTING
TM 9-2350-256-20
WARNING
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry contacts a metal
surface a direct short may result in instant
heating of tools, damage to equipment, and
injury or death to personnel.
D
Remove four screws (1) and four lockwashers (2) and
release electrical accessories panel (3). Reconnect
electrical
accessories
panel
wiring
harness
to
electrical accessories panel. Disconnect wire 38/518
from winch light switch side of 15 A circuit breaker.
Place red lead of multimeter on terminal of 15 A
circuit breaker and black lead to ground. Turn
MASTER switch on, and check for voltage. Turn
MASTER switch OFF. If voltage is present,
repair/replace wire 38/518 of bilge pump main power
wiring harness from 15 A circuit breaker to electrical
accessories panel wiring harness connector (see
paragraph 6-84). If voltage is not present, go to step
E.
E
Reconnect wire 38/518 to winch light switch side of 15
A circuit breaker. Disconnect wire 38/518 from panel
connector side of 15 A circuit breaker. Place red lead
of multimeter in wire 38/518 and black lead to ground.
Turn MASTER switch on, and check for voltage. Turn
MASTER switch OFF. If voltage is present, replace
15 A circuit breaker (see paragraph 6-9). If voltage
is not present, repair/replace wire 38/518 from pin A
to 15 A circuit breaker (see paragraph 6-9).
2-255
