SECTION IV: LIGHTING SYSTEM
TM 9-2350-256-20
NOTE
Clean and dry all parts, paying particular attention to contacts.
b. DISASSEMBLY
1
Remove door light assembly (10) by loosening six
captive screws (11).
2
Remove and discard preformed packing (12).
3
Remove two lamps (13) by depressing and turning
counterclockwise.
4
Disassemble wiring harness (see Chapter 6,
Section VII).
c. ASSEMBLY
1
Assemble wiring harness (see Chapter 6, Section
VII).
2
Install two lamps (13) by depressing and turning
clockwise.
3
Install new preformed packing (12).
4
Install door light assembly (10) by tightening six
captive screws (11).
d. INSTALLATION
1
Install taillight (6) on support bracket (7) using two screws (8) and two new lockwashers (9).
2
Install grommet (5) over two connectors (4) and then place grommet into hole on hydraulic access plate
(1).
Connect connectors.
3
Install hydraulic access plate (1) using two screws (2) and two lockwashers (3).
6-31 REPLACE TROUBLELIGHT ASSEMBLY
THIS TASK COVERS
a. Removal
b. Installation
INITIAL SET-UP
Tools:
Parts:
Tool kit, general mechanic's (Appendix C, item 53)
Lockwashers (2) (Appendix G, item 108)
WARNING
Be certain MASTER switch is OFF when working on electrical system to avoid electrical shock and bums.
6-67
