CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS
TM 9-2350-256-20
6-30 REPLACE/REPAIR STOPLIGHT-TAILLIGHT ASSEMBLIES
THIS TASK COVERS
a. Removal
b. Disassembly
c. Assembly
d. Installation
INITIAL SET-UP
Tools:
Parts:
Tool kit, general mechanic's (Appendix C, item 53)
Lockwashers (4) (Appendix G, item 108)
Lockwashers (4) (Appendix G, item 134)
Packing, preformed (Appendix G, item 185)
WARNING
Be certain MASTER switch is OFF when working on electrical system to avoid electrical shock and bums.
NOTE
The following procedures are the same for both left and right taillights.
Left taillight requires three lamps and right taillight requires two lamps.
a. REMOVAL
1 Remove hydraulic access plate (1) by removing two
screws (2) and two lockwashers (3).
2 Disconnect two connectors (4). Remove grommet
(5) from each lead and pull connectors through
grommet hole.
3 Remove taillight (6) from support bracket (7) by
removing two screws (8) and two lockwashers (9).
6-66
