Removal - TM-9-2350-292-20-1

HYDRAULIC OIL COOLER AND RELATED PARTS REPAIR

Removal (cont) - TM-9-2350-292-20-1_1191

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
1141

TM 9--2350--292--20--1 0230 00--2 HYDRAULIC OIL COOLER AND RELATED PARTS REPAIR -- CONTINUED 0230 00 Removal--Continued WARNING WARNING Hydraulic system pressure is rated 4450 psi. Do not torque hydraulic fittings or perform removal procedures when hydraulic system is pressurized. Discharging sys- tem before performing any maintenance procedures will prevent injury to personnel. 2. Disconnect two hydraulic line quick--disconnect couplings (3). NOTE Cap all hydraulic lines and plug all hydraulic ports to pre- vent contamination. Place suitable container under con- nections to catch spillage. 3. Disconnect two hydraulic lines (4) at adapters (5). 4. Remove four nuts (6), four lockwashers (7), eight flat washers (8), four screws (9), oil cooler (10) and gasket (11). Discard lockwashers and gasket. 5. Remove two adapters (5) and two preformed packings (12) from oil cooler (10). Discard packings. NOTE There are only nine screws, nine lockwashers securing the left cooler hood assembly. 6. Remove 10 screws (13), 10 lockwashers (14) and cooler hood assembly (15). Discard lockwashers. Figure 38 3 4 5 6 7 8 9 8 10 11 12 13 14 15 12 4 5 11 3

Privacy Statement
Press Release
Contact