TM 9--2350--292--20--20635 00--2AUXILIARY POWER UNIT GENERATOR REPLACEMENT (HATZ) --CONTINUED0635 00Removal--Continued4. Remove self--locking nut (8), three lockwashers (9) and two ground wires (10 and 11) from terminal E of generator(7). Discard lockwasher and self--locking nut.5. Remove self--locking nut (12), flat washer (13) and wire (14) from terminal D of generator (7). Discard self--lockingnut.6. Remove self--locking nut (15), flat washer (16) and wire (17) from terminal A of generator (7). Discard self--lockingnut.7. Remove self--locking nut (18), flat washer (19) and wires (20 and 21) from terminal B of generator (7). Discardself--locking nut.1413122118192015161778109911WARNINGTo avoid personnel injury or death, use extreme cautionand observe safety precautions when working under-neath the APU.CAUTIONTo avoid APU damage a suitable holding device is neces-sary to ensure APU weight does not rest on either gener-ator or hydraulic pump. APU must be raised high enoughto permit access to underside.Generator weighs approximately 94 lbs (43 kg). To pre-vent damage to shaft and seals, generator must be sup-ported at all times when performing the following proce-dures.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business