TM 9--2350--292--20--20502 00--1PAYOUT LIMIT SWITCH ADJUSTMENT0502 00THIS WORK PACKAGE COVERS:Removal, InstallationINITIAL SETUP:Tools and Special ToolsGeneral mechanic’s tool kit(item 1, WP 0717 00)Torque wrench (item 21, WP 0717 00)Equipment ConditionsMain winch and spade assembly removed(WP 0497 00)ReferencesTM 9--2350--292--10NOTEThis task must be performed with wire rope installed.Adjustment1. Install wire rope on drum using wire rope installation procedure (WP 0499 00).2. Install main winch ground hop kit (WP 0498 00).3. Operate main winch (TM 9--2350--292--10), stop winch drum (1) when upper roller end cap (2) makes contact withwire rope (3) during fourth or fifth wrap and upper spooling roller (4) begins to rise.4. Adjust height of payout limit switch (5) by sliding it vertically on slots (6) in mounting bracket. Correct position iswhen nylon roller (7) on lever arm (8) is centered on lug (9) of spring guide bracket (10).5. Torque payout limit switch bracket attachment screws (11) to 72 lb--in (8.14 NSm).Figure 264124561011423879
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business