TM 9--2350--292--20--2
0500 00--1
MAIN WINCH AND SPADE QUICK--DISCONNECT COUPLINGS AND
ADAPTERS REPLACEMENT
0500 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Open--end wrench (item 75, WP 0717 00)
Open--end wrench (item 95, WP 0717 00)
Combination wrench (item 98, WP 0717 00)
Combination wrench (item 30, WP 0717 00)
Open--end wrenches (2) (item 105, WP 0717 00)
Open--end wrench (item 106, WP 0717 00)
Materials/Parts
Lubricant (item 31, WP 0716 00)
Sealing compound (item 16, WP 0716 00)
Safety goggles (item 93, WP 0716 00)
Equipment Conditions
Subfloor plates #10 and #15 removed (WP 0454 00)
Main winch and spade assembly removed, as required
(WP 0497 00)
WARNING
WARNING
WARNING
Do not attempt to loosen or tighten hydraulic fittings or
lines when the system is pressurized. Ensure that boom
and spade are in stowed positions before performing any
maintenance on hydraulic system. A high pressure oil
stream can cause severe injury to personnel.
NOTE
This procedure applies to any quick--disconnect coupling
(male or female) and adapter on main winch and spade
assembly.
Some quick--disconnect coupling adapters require pre-
formed packings (refer to repair parts manual for replace-
ment parts) and some do not.
