REMOVAL (cont) - TM-9-2350-256-20

TM-9-2350-256-20 Carrier Cargo Tracked 6-Ton M548A1 (2350-01-096-9356) M548A3 2350-01-369-6081 Manual
Page Navigation
1057

CHAPTER 9: MAINTENANCE OF HULL-AND CAB RELATED COMPONENTS TM 9-2350-256-20 9-80 REPLACE/REPAIR/SERVICE SERVICE BRAKE CONTROLS AND LINKAGES--Continued 22 Remove rod assembly (67) from levers (56 and 68) by removing two screws (69) and two lockwashers (70). 23 Remove rod end (71) and nut (72) from each end of rod assembly (67). 24 Remove rod assembly (73) from levers (68 and 74) by removing two screws (75) and two lockwashers (76). 25 Remove rod end (77) and nut (78) from each end of rod assembly (73). 26 Remove levers (56 and 68) by removing from each two lockwashers (79), two screws (80), pin retainer (81), lubrication fitting (82), and grooved pin (83). NOTE If removal of bracket assembly (84) is required, remove accelerator controls and linkages as necessary (see paragraph 9-78). 27 Remove bracket assembly (84) by removing six screws (85), six lockwashers (86), and three flat washers (87). 28 Disconnect rod assembly (88) from lever (74) by removing screw (89) and lockwasher (90). Remove rod assembly from plate assembly (91) by removing cotter pin (92), grooved pin (93), and lubrication fitting (94). Remove rod end (95) and nut (96) from rod assembly. 29 Remove bracket assembly (97) and lever (74) by removing lubrication fitting (98), cotter pin (99), grooved pin (100), four screws (101), and four lockwashers (102). 9-188

Privacy Statement
Press Release
Contact