TM 9--2350--292--20--20699 00--6FIXED FIRE EXTINGUISHER ACTUATOR CABLE ASSEMBLY REPAIR --CONTINUED0699 00Assembly1. Lubricate cable assembly (10) with graphite.2. Connect adapter (37) onto pulley (41).3. Thread and connect cable assembly (10) through pulleys (34, 40, 41 and 42), four conduits (11, 19, 38 and 39)and dual pull mechanism (32).4. Insert three cable assembly ends (10) in cable clamp (43).5. Squeeze cable clamp (43) tightly along its entire length.6. Grasp both ends of cable clamp (43) at each end approximately 0.18 in. (0.46 cm).7. Rotate the ends of cable clamp (43) in opposite directions simultaneously until cable clamp has been twisted toone and one--half turns.8. Cut short ends of cable (10) to within 0.06--0.25 in. (0.15--0.64 cm) of cable clamp (43).Figure 369GRASP CABLE CLAMPENDS 0.18” (0.46cm)CUT CABLE AT CLAMP END0.06”--0.25” (0.15--0.64cm)343940103741383243104211101043101043101019
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
