TM 9--2350--292--20--2
0667 00--11
DEEP WATER FORDING KIT -- CONTINUED
0667 00
Installation--Continued
MAIN ENGINE AIR INLETS
NOTE
There are two air cleaner air inlet covers. Installation pro-
cedures are the same for both.
1. Remove and stow two screws (1), two lockwashers (2), plate (3), two screws (4), two lockwashers (5), guide (6)
and screen (7). Discard lockwashers.
2. Remove and stow two screws (8), two lockwashers (9), two flat washers (10), hood (11), plate (12) and cover (13)
and screen (14) from hull. Stow screen (14), air inlet cover (13), hood (11) and plate (12). Discard lockwashers.
3. Remove protective covering from top of seal (15). Place seal over opening in hull with adhesive side facing up.
4. Install elbow (16) in left air inlet pipe (17).
CAUTION
Make sure air inlet pipes tilt slightly to outside of vehicle
to ensure boom clears pipe during raising and lowering
operations. Failure to comply will result in damage to
equipment.
5. Install air inlet pipe (17) and plate (18) over inlet seal (15) with four screws (19) and four new lockwashers (20).
6. Apply adhesive (MIL--A--46106 11EBN) around base of air inlet pipe (17) and heads of four screws (19) using
brush.
Figure 354
1
2
3
20
19
11
5
6
8
9
10
7
12
13
4
17
14
15
18
16
359
Figure 355