TM 9--2350--292--20--2
0392 00--4
ADJUSTING LINK AND COMPONENTS REPAIR (OLD CONFIGURATION) --
CONTINUED
0392 00
Installation
NOTE
Link assemblies must be installed in front suspension as-
sembly so that lock screws and valve assemblies are ori-
ented upward and toward rear of vehicle.
1. Apply antiseize compound to threaded ends of clevis pins (2) and (8).
2. Install end of adjusting link (5) to vehicle with clevis pin (8), flat washer (10) and nut (9).
3. Install new cotter pin (7) in clevis pin (8).
4. Connect the other end of adjusting link (5) to hub and arm assembly (6) with clevis pin (2), flat washer (4) and nut
(3).
5. Install new cotter pin (1) in clevis pin (2).
Figure 183
1
2
3
4
5
6
7
8
9
10
NOTE
FOLLOW--ON MAINTENANCE:
Install idler hub assembly (WP 0394 00)
Install lower armor skirt panel #1 support
(WP 0442 00)
END OF TASK
